![]() In the June 3 incident, an oncoming vehicle was traveling 40 miles per hour in a 25-mph restricted right-turn/bus-only lane as the Cruise AV was making an unprotected left turn, according to the regulatory filing. #Cetus3d software crash updateCruise installed a software update so this scenario would not recur. “The report explains how the Cruise AV responded to an oncoming vehicle speeding in the wrong lane, and how through our normal course of continuous improvements, Cruise AVs are even better equipped to prevent this singular, exceptional event,” the Cruise statement continued.Ĭruise said that only one such incident has occurred in over 123,560 driverless unprotected left turns performed prior to the updated software release. ![]() ![]() #Cetus3d software crash driverThe crash, which resulted in minor injuries to two riders, received national attention because it occurred a day after Cruise received the final permit from California regulators to commercialize its driverless robotaxi service.Ĭruise said in a regulatory filing with the National Highway Traffic Safety Administration that the software recall was issued because of a “rare circumstance” in which the automated driving system caused the driverless robotaxi - which did not have a human safety driver behind the wheel - to hard brake while making an unprotected left turn.Ĭruise said in an emailed statement that it submitted the voluntary filing in the interest of transparency to the public and added that it pertains to a prior version of software and does not impact or change its current on-road operations. Luckily the new barrel is really easy to unclog.Cruise, the autonomous vehicle unit under GM, reported a software recall and update in 80 of its robotaxis following a crash in June. I thought this was a really strange behavier, because the nozzle is hot enought to get the high flow part of the print done but not the low flow sections?!? However after a few more tries of raising the temperature and test-printing, this was my best result and in the end my nozzle got too hot, melted the filament right in top of the barrel and clogged. Another temperature rise later the printer finished printing the raft and then started skipping at the first bottom layer. But I’ve been pleased too early and right at the moment as the printer started with the thin raft lines, the extruder started skipping again. I started a test print and while the nozzle was laying down some first fat raft lines, I was happy that my printer was back in business again. There is no silicone sock on this nozzle, maybe raising the temperature will help. The new nozzle arrived but at its first feed the extruder started skipping again while pushing out just a little bit of filament. It was my last nozzle so i decided to order the new V2 barrel and give that wear resistant nozzle a try. I have already had pushed about 3 rolls through its tiny. Tries to clean it failed with the same result. ![]() At first i thought it was a clogged nozzle. ![]() It already has the V1 extruder installed.Ī few weeks ago my extruder started badly skipping steps while printing PLA. I own my Cetus MK2 for round about 3 years now. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |